Probe/limit switch not working

 

When the control software indicates that a limit switch is active or not working, you can check which switch it is.

To do this, go to the DIAGNOSTICS tab. Here, on the right side under ORGIN, you will see "led 's" next to X, Y, and Z. When one or more LEDs are lit, this means that switches are active. It is possible that a switch remains stuck. If you then disconnect the plugs of the various shafts from the control box one by one, you can check at which motor/shaft the LED goes out. This way, you know which switch is involved.

 

Here you can also check the PROBE IN switch by manually lifting the torch slightly.. The LED light on the screen will then light up.