Video (Dutch)

Video (German)

Start in the middle of the program and adjust speed while cutting

It is possible that a malfunction may occur during cutting. You do not need to replay the entire program.

If you want to start somewhere in the middle of the program, you can follow the steps below. However, it is not possible to start in the middle of a contour. This is only possible at the beginning of a contour. 

Scroll through the g-code and find the desired starting point of the contour. In most cases, this is after a code M5. 

Next, click on the arrow next to the g-code. To the right of the arrow, the g-code line is displayed with a number, from where the program will start. 

Click PLAY after you have clicked on the arrow. 

Adjust speed while cutting.

If the programmed speed is slightly too high or too low, you can adjust it during cutting. This can be done using the arrow keys next to the FEEDRATE.

When you press reset in the middle, the speed returns to the programmed speed.