Video (Dutch)

Video (German)

Start in the middle of the program and adjust the speed while cutting

During cutting, a malfunction may occur. You do not have to replay the entire program.

If you want to start somewhere in the middle of the program you can follow the steps below. However, it is not possible to start in the middle of a contour. This  can only be done at the beginning of a contour.

Scroll through the g-code and find the desired starting point of the contour. In most cases this is after a code M5.

Then click on the arrow next to the g-code. To the right of the arrow is a number showing the g-code line from which the program will start.

After clicking the arrow, click PLAY.

Adjust speed while cutting.

If the programmed speed is just a little too high or too low, you can adjust it during cutting. This can be done by using the arrow keys at the FEEDRATE.

When you press reset in the middle, the speed will return to the programmed speed.